Workflow runs fine manually but fails after publishing

Questions
1

Hi everyone,

I’m facing an issue where my workflow runs perfectly when triggered manually, but once I publish/activate it, it fails to execute properly.

When I check the execution details, I don’t see any errors in any of the nodes — everything appears successful, but the expected outcome doesn’t happen.

Has anyone experienced this behavior before?
Are there differences in execution context between manual runs and active workflow runs that I should check (e.g., credentials, trigger payload, environment variables, etc.)?

Any suggestions on what could cause this would be really helpful.

Thanks in advance!

1 Like
2

Hi @Marketing_Tools Can you share your workflow with us? And the kind of output you are expecting from it, as you have mentioned everything works fine in manual runs but in published mode it does not meet the required output you are expecting, please consider sharing your workflow and detailed outcome along with information about your n8n instance.

1 Like